Painting,  Renovations,  Trim and Moldings

Changing up the Entryway

With the heat continuing outdoors (humidity sucks) work continues indoors. When we painted the living room two weeks ago, we brought the same paint into the entryway since they are open to each other. We just painted the upper portion of the walls knowing we would get around to finishing it off sooner or later. No time like the present.

painting the living room
This corner needs something

We started in the workshop, cutting strips of thin plywood (luan) into strips about 4 inches wide and 70 inches long.

entryway
Cutting the strips

I was on the other end helping to guide the plywood since we were working with such a long piece. Once we had enough pieces cut, Jim gave them a quick hand sanding, mainly along the edges.

entryway
It’s all a blur

We had thrown around ideas for installation before we started, some of which involved removing the baseboards. Hoping to avoid that if at all possible, we settled on using this thin plywood and resting it directly on the top of the baseboards. Some smart we are. We started at one corner and worked our way across the wall using a quarter as a spacer.

entryway
Quarter spacer

We used the nail gun to attach the boards to the wall.

entryway
Coming along

We continued around the three walls. The second wall has the back door and the third wall has double closet doors so those went fairly quickly. Here is a close up look of the boards spaced out evenly.

entryway
Luan boards

On the one uninterrupted wall, we added a 10 inch wide board directly on top of the luan boards, then attached a 7 inch shelf.

entryway
Adding the shelf

Next up we needed brackets for the shelf. At first we were going with two brackets but changed our minds and went with three. Glad we did. So it was back to the workshop to make the brackets.

First Jim made a template which we brought into the house to see if the proportions were right. We made a few changes to the template, then Jim glued and nailed three pieces of wood together to make up one bracket.

entryway
Nailing the bracket

We traced the template onto the wood and headed over to the bandsaw to do the cutting.

entryway
Cutting out the bracket

We did this times three and after lots of sanding it was time to attach our brackets to the wall. You can also see we added trim to the top of luan boards on the other two walls.

entryway
Nailing on the brackets

With installation finished it was time to fill ALL the holes and once that was dry it got a good hand sanding.

entryway
Filling the holes

Next up was painting. We painted a coat of primer and two coats of white paint.

entryway
First coat just soaked in

With the paint dry and all touch-ups done we added four black coat hooks.

entryway
Ready for coats and hats

It is hard to get a good picture of the whole area since it is 6 feet wide to the closet doors. Here goes…The closet side,

entryway
All finished

And the bench side…

entryway
Nice and white

And the whole space.

entryway
Another job done

So far we are digging it. While the paint cures, I am deciding what to put of the shelf if anything. Now I may need to paint the front door. Hmmm…

Have a great long weekend if you live in Canada.

Later

Leave a Reply

Your email address will not be published. Required fields are marked *

Time limit is exhausted. Please reload CAPTCHA.

This is a showcase environment. Please contact us for purchases. Dismiss