Decks,  Renovations

Deck in the round part 6

Custom lighting for a deck
Lighting installed

So this is a close up shot of a completed post with the cap installed. The cap is attached with two deck screws through the top down into the sides of the post.

 

 

 

Custom lighting for a deck
Lighting installed

Some other features of the deck. This is a shot of the steps leading to the top deck. 5/4 by 6 inch pressure treated deck boards were edge joined then cut to fit for the inside piece. Then a straight board was placed for the front.

Building a round deck
Curved steps on a round deck

And this is a shot of the steps leading to the middle level. Again the same method was used. I decided to use a straight board for the outside board because it will be easier to replace when it wears or if the edge breaks.

Building a round deck
DIY deck steps.

So here’s a before and after.

Time for a new woodworking project.
Old deck, rotten wood.
DIY round deck construction.
tri level round deck
Time for a deck renovation.
Old deck in disrepair.
DIY round deck.
Skirting still needs to be installed.

The beginning | Previous | The Grand Finale!

 

 

A Newfoundland born Canadian with a life long interest in woodworking, baking and anything else that peaks my curiosity.

Leave a Reply

Your email address will not be published. Required fields are marked *